Falcon

Falcon

Part Number	X812320
Introduced	Late 2007
Used In	Xbox 360 (Original)
CPU Type	Loki
GPU Type	Rhea
CPU Process	65nm
GPU Process	90nm
eDRAM Process	90nm
Nand Size	16MB (Retail) 64MB (Dev)
Video Outputs	A/V and HDMI
Wattage	175W
12V Amperage	14.2A
Predecessor	Zephyr_C
Successor	Jasper

Falcon is the successor to the Zephyr_C motherboard and is used in the Original Xbox 360 series.

Notable Differences

• The Waternoose CPU has been replaced with the Loki CPU
• Around March 2008, fixed GPUs started being used in some units, but was not universally used until roughly June/July 2008
• When the revised GPUs started rolling out, almost all boards started using Qimonda HYB18H1G321AF-14 RAM in a 4x128MB config
• Qimonda HYB18H512322AF-13 RAM has been replaced with Qimonda HYB18H512321BF-14
• When the revised GPUs rolled out, Hynix HY5RS123235BFP-14 and Qimonda HYB18H512321BF-13 RAM are no longer used
• The V_CPUCORE voltage regulation is now 2 phases, down from 3 phases, but the pads and silkscreen for the third phase still remain
• The V_CPUVCS rail was added for the Loki CPU, as VCS is no longer on silicon
• The board layout has been modified to support the Loki CPU
• The J7G3 Titan connector on the front of the motherboard was left on the final motherboard
• Some later boards use solid state capacitors for the CPU and GPU output filters
• The heatpipe CPU heatsink was replaced with the aluminum CPU heatsink, however some early systems did not have this change

Specifications

• 65nm Loki CPU
• 90nm Rhea GPU/eDRAM
• 512MB GDDR3 RAM
  • 8x64MB Hynix HY5RS123235BFP-14 (Early Boards)
  • 8x64MB Qimonda HYB18H512321BF-14 (Early Boards)
  • 4x128MB Qimonda HYB18H1G321AF-14 (Mid/Late Boards)
• XSB R0 Southbridge
• HANA
• Nand
  • 16MB Hynix HY27US08281A (Retail)
  • 64MB Samsung K9F1208U0B (Dev)
• Boardcom or ICS Ethernet PHY
• Aluminum CPU Heatsink
  • Heatpipe CPU Heatsink used on early units
• Extended GPU Heatsink

Opus

Falcon that has been converted to an Opus

The Opus name describes a project of fitting a Falcon board into the casings for a Xenon. This was done with a custom A/V port and the removal of the HDMI port. Opus was used for refurbishing defective consoles until the Elpis boards started being produced.

Notable Differences

• Removal of the HDMI port
• Custom A/V port to fit the HDMI board layout while being able to fit into the Xenon casing
• All Opus boards use revised versions of the Rhea GPU with higher Tg underfill