Heatsink

See also: Fan

The Xbox 360 has used multiple different type of heatsinks for cooling the processors.

Xbox 360 (Original)

The Original Xbox 360 used 2 heatsinks: one for the CPU, and one for the GPU. There were also 2 different versions of each heatsink.

Heatpipe CPU

Used on the Xenon, Zephyr, and Elpis motherboards. It was also used on very early versions of the Falcon motherboard. Later revisions found on late 2006 and newer boards had less of a cutout near the rounded heat pipe on the side.

• 
• 

Aluminum CPU

Used on the Falcon, Jasper, and Tonasket motherboards.

• 
• 

Low Profile GPU

Used on early/mid Xenon motherboards, Zephyr_A motherboards, and returned on the Tonasket motherboard.

• 
• 

Extended GPU

Used on late Xenon, Zephyr_B/C, Elpis, Falcon, and Jasper motherboards.

• 
• 

Xbox 360 S and Xbox 360 E

The Xbox 360 S and Xbox 360 E use a single heatsink for the CGPU. There were 2 versions of the heatsink. Both versions have a fan mounted on them.

• 

  Heatsink with a fan mounted on top

• 

  Bottom of the heatsink

Tall Slug

Used on the Trinity motherboard. This heatsink was only used for a brief time.

• 

Short Slug

Used on the Trinity, Corona, Waitsburg, and Stingray motherboards. It was also used on Winchester with slightly shortened pegs on the bottom, as Winchester removed the integrated heat spreader.

• 

Prototypes

The following heatsinks were used on different Xbox 360 console variations.

Xbox 360 Cooler Master Fan & Heatsink

Used internally in a variety of applications. This heatsink featured a copper slug and a downward-facing Cooler Master fan. The thermal interface material (TIM) that was used on this was sized for up to a Shiva CPU.

• X360 CM Int HS (1).jpg
• X360 CM Int HS (2).jpg
• X360 CM Int HS (3).jpg
• X360 CM Int HS (4).jpg
• X360 CM Int HS (5).jpg
• Xbox-360-xavbox.jpg

Xbox 360 Solid-Copper Base Heat Pipe Heatsink

Used on early xenon prototypes, this heatsink featured solid copper base and was used on both Shiva and DD1 CPUs. When used with a Shiva CPU, the standoffs were lengthened to account for the taller IHS. Due to this, the heatsink fins were shorter than that of the final heatsink.

Xbox 360 S Cooler Master Fan & Heatsink

Used on early Trinity prototypes, this heatsink is thicker than the final heatsink and does not feature a copper slug. This was used in correlation with a different fan shroud as well with F92 markings. This was seen publicly in a leak before the trinity motherboard was released.

• Part Number: X820716-002 REV G

• X360S CM (2).jpg
• X360S CM (5).jpg
• X360S CM (6).jpg
• X360S CM (7).jpg
• X360S CM (9).jpg
• X360S CM (1).jpg
• X360S CM (8).jpg
• 500x xbox-motherboard.jpg