Fan

See also: Heatsink

The Xbox 360 has used multiple different type of fans for cooling the processors. The fans are controlled by the SMC using the Thermal Algorithm.

Dual Fan

Dual fan assemblies were used in the Original Xbox 360 and pulled air through the heatsink through a shroud. There are 3 different fans used from different vendors. For Xenon motherboards, the connector is a 4-pin connector, with a power and ground for each fan. All other models use a 3-pin fan connector with a common ground and power for each fan.

Delta

• Model: AUB0712HH

• 

  Top

• 

  Bottom

Nidec

• Model: E35427-55MIC13

• 

  Top

• 

  Bottom

Sunon

• Model: KDE1207PTVX-A

• 

  Top

• 

  Bottom

Single Fan

The Xbox 360 S and Xbox 360 E used a single fan mounted directly to the heatsink in a more traditional configuration. There are 4 different fans used from different vendors. They use a 4-pin PWM connector.

Cooler Master

• Model: FA09025H12LPA

• 

  Top

• 

  Bottom

Delta (Type 1)

• Model: AUB0912HH

• 

  Top

• 

  Bottom

Delta (Type 2)

• Model: AUB0912HH

• 

  Top

• 

  Bottom

Foxconn

• Model: AUB0912HH

• 

  Top

• 

  Bottom

Prototypes

The following fans were used with prototype consoles.

Xbox 360 S Cooler Master Fan

Used with early Xbox 360 S trinity prototypes, this fan was slimmer than final fans and was mounted to a taller heatsink. To see more, see heatsinks.

• Model: A9020-30CB-4AP-C1

• X360S CM (10).jpg
• X360S CM (11).jpg
• X360S CM (3).jpg